Long-term use can result in O-ring wear.Unscrew the tail cap or remove the battery to prevent accidental activation during storage or transportation.If the light will not be used for an extended period, remove the battery for proper storage.Fenix recommends using only a high-quality protected battery.Disassembling the sealed head can cause damage to the light and will void the warranty.Note: This only works with Fenix ARB-L18 series 18650 battery. When this happens in Eco output, the battery level indicator constantly blinks red to remind you to recharge or replace the battery. When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Eco output is reached. When the temperature drops below 60☌, it will then allow the user to reselect the modes. When the light reaches a temperature of 60☌ or above, the light will automatically step down a few lumens to reduce the temperature. The light will accumulate a lot of heat when used at relatively high modes for extended periods. Green light flashes: sufficient 85% - 50%.If under the locked state, single click the functional switch to check the battery level. Unscrew the light head to insert the battery with the anode side (+) towards the light head, then screw the light head back on.Įach time the light is turned on on Tactical or Duty mode, the indicator in the functional switch will indicate the battery level and will last for 3 seconds. * 18650 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. Only use quality batteries with circuit protection will reduce the potential for combustion or explosion but cell damage or short circuiting are potential risks the user assumes. Doing so may cause damage to the flashlight or the batteries being used. Warning: Do not mix batteries of different brands, sizes, capacities or types. Unlock Rotate the toggle switch to Tactical mode or Duty mode to unlock the light.įenix TK35UE V2.0 Battery Specifications Type * Press and hold the functional switch over 3 seconds to start or stop the battery level indicator from alternately blinking red and green. The battery level indicator blinks red and green to indicate the light is locked. At this time, single click the tactical switch. With the light switched off, rotate the toggle switch to the right to lock the light. At this time, the light will go out and the battery level indicator blinks red and green to indicate the light is locked. With the light switched on, rotate the toggle switch to the right to lock the light. When turned on again the previously used output of Duty mode will be recalled. *The light memorizes the last selected output excluding strobe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |